
FAQ - INFRAROODVERWARMING VOOR BUITEN
INSTALLATIE
STAR18RS (NORVECO) KACHEL START NIET OF GEEFT FOUTCODE E3!
DEACTIVATE TITLT SWITCH FOR STAR18RS
The tilt protection can be disabled. Please follow the instructions below:
“E3” indicates that the tilt switch is activated.
It is possible to deactivate the tilt switch. We have made it deliberately more challenging to prevent customers from accidentally disabling it. I will explain the steps one by one:
- First, you need to unplug and reconnect the heater. (Have the remote control ready because you only have a few seconds to make the changes after reconnecting.)
- Immediately after reconnecting, when you see the lights circling, you must press the timer button (bottom-right), the thermostat button (bottom-left), and the level button (center) within 2 seconds.
- If you did this part correctly, you should see the letter A or P on the display. This means you succeeded.
- Since the default setting is for the tilt-over switch to be active, you should see the letter A. Now, you can use the + and – buttons to toggle between A and P. To deactivate the tilt switch, set it to P, and then you can turn off the unit using the power button.
When you turn it on again, the tilt switch should be deactivated, and it will remain so unless you repeat the steps to activate it again.
Please also see this video, which shows the process described above.
https://opranic.com/external/video/norveco_star18rs_tilt.mp4
MIJN VERWARMING START NIET OF GEEFT EEN FOUTCODE!
THESE INSTRUCTIONS ARE FOR V50 or V70 Series with remote control
If the display on the heater shows “ER” when it is connected to the power grid, this may indicate that the electronic tilt switch is activated. Follow these steps to deactivate the tilt switch:
Make sure the heater is positioned so that the LCD screen is facing up or angled up to 90° to the right or left. It must not be facing down.
When you turn on the power to the unit or plug it into an outlet, press “T-” and then immediately “T+”. The display will then show “OF” or “ON” – where “OF” means that the tip-over protection is deactivated and “ON” means it is activated.
Select “OF” to deactivate the electronic tilt switch.
When the tilt switch is deactivated, the heater can operate in all directions and can be mounted on a wall or ceiling.
Note: For safety reasons, the heater cannot be placed on a stand when the tilt switch is deactivated.
The heater now works in all mounting directions and can only be mounted on a wall or ceiling.
NOTE! For safety reasons, the heater cannot be mounted on a stand when the tilt switch is deactivated.
WAAR KAN IK OPRANIC PRODUCTEN VINDEN?
De producten van OPRANIC worden verkocht via de groothandel, winkels en e-commerce.
In elk land streven we ernaar om een distributeur te hebben die de producten lokaal distribueert naar detailhandelaren en groothandelaren.
Je kunt onze producten ook rechtstreeks op onze website https://www.opranic.com kopen.
KAN IK HET OP EEN HOUTEN MUUR BEVESTIGEN?
Ja, zolang u zich houdt aan de veiligheidsafstanden die staan vermeld in de handleiding bij het verwarmingselement.
Deze is ook beschikbaar in onze mediabibliotheek.
HOE LANG IS DE VOEDINGSKABEL?
De kabellengte varieert van 1,85 tot 1,95 meter, afhankelijk van het model, en het heeft een F-stekker van het Europese type.
WAT IS INBEGREPEN IN HET PAKKET
De aankoop omvat een verwarmingselement, handleiding, schroeven, 4 montagebeugels en een afstandsbediening voor de “R”-versies.
Als je iets mist in je doos, neem dan contact met ons op en we sturen het ontbrekende onderdeel onmiddellijk op.
WAT IS DE AANBEVOLEN INSTALLATIEHOOGTE?
Voor wand- of plafondmontage moet de afstand tot de vloer ten minste 1,8 meter zijn, in overeenstemming met de CE-voorschriften.
Een aanbevolen installatiehoogte, bijvoorbeeld voor een terras, is 1,8-2,3 meter voor vermogens tot 2300 W. De VEGA-serie vereist hogere installatiehoogten vanaf 4 meter.
KAN IK EEN VERLENGSNOER GEBRUIKEN?
Gebruik geen verlengsnoer, want dat kan oververhit raken en brand veroorzaken. Als een verlengsnoer nodig is, moet het minstens 1,5 mm groot zijn en een nominale stroomsterkte hebben van minstens 10 A. Sluit niet meerdere elektrische apparaten aan op het verlengsnoer om overbelasting te voorkomen.
HOE TE GEBRUIKEN
KAN IK DEZELFDE AFSTANDSBEDIENING GEBRUIKEN VOOR MEERDERE VERWARMERS?
Ja, de afstandsbediening is hetzelfde voor alle Opranic verwarmers met afstandsbediening.
Als je twee verwarmers koopt, kun je dezelfde afstandsbediening voor beide verwarmers gebruiken.
Richt de afstandsbediening gewoon op het verwarmingselement (maximale afstand 8-10 meter) en selecteer het gewenste vermogen.
KAN IK HET VERMOGEN VAN DE THERMOSTATISCHE MODELLEN AANPASSEN?
Nee, de thermostatische modellen hebben geen vermogensniveaus.
Er zit een temperatuursensor in het verwarmingselement die in- en uitschakelt afhankelijk van de temperatuur van het verwarmingselement.
Je kunt de thermostaat zo instellen dat hij meerdere keren per uur aan en uit gaat, of op maximaal zetten voor continu gebruik.
ZIJN OPRANIC KACHELS WINDBESTENDIG?
Theoretically, you will always have the same level of radiant heat on your skin regardless of the ambient temperature. However, the cooling effect caused by low temperatures and air movements cools the skin and to compensate for this you need to add more energy (heat).
Opranic heaters convert 96% of the energy into radiant heat, so Opranic heaters are very efficient, have the highest wind resistance of all outdoor heaters on the market due to the unique radiation technology which also has a very high absorption level for human skin.
For an insulated indoor room, a 2300W heater is sufficient to heat up 23 square meters. But for an outdoor environment where you have no insulation and the energy is consumed by constant air movements, a 2300W heater covers an area of approximately 13 square meters.
See our images and guides for heat coverage in the sidebar to the right.
If you need further assistance, please contact us!
IS ER EEN STANDAARD VOOR HET VERWARMINGSELEMENT?
No, we do not offer a stand for the wall-mounted heaters due to safety regulations. Mounting a wall-mounted heater on a stand may violate legal requirements and pose serious risks. Wall-mounted heaters are designed to be installed on walls and meet specific safety and performance standards for that configuration.
If you need a portable heating solution, we recommend our heaters in the THOR or STAR series. These models are specifically designed to be portable and meet the necessary safety regulations for portable infrared heaters. They provide safe and efficient heating while complying with all necessary standards.
ONDERSTEUNING EN GARANTIE
ZIJN OPRANIC VERWARMERS BESTAND TEGEN ROEST EN OXIDATIE?
Opranic heaters are made to withstand rust and oxidation. Strong direct sunlight, snow, and other weather conditions deteriorate all materials over time, so to keep your heater in good condition, we recommend either installing it under a roof or covering it for an extended period when not in use.
The housing is made of aluminum and will have very little degradation from outdoor use.
The front grille is made of chrome-plated steel and may have some tendency to react to an outdoor climate. However, if you experience that the front grille deteriorates, it is possible to replace the grille. Contact us and we will help you with a replacement front grille.
The side covers are made of special fiberglass-reinforced plastic which has a very high level of protection against all weather influences. But if you have accidentally dropped the heater and the plastic has broken, contact us and we will help you with a new side cover.
WAT VOOR GARANTIE ZIT ER OP HET VERWARMINGSELEMENT?
Opranic verwarmers hebben een garantie van 2 tot 5 jaar, afhankelijk van het model.